Control Top Disassembly; Radio Reassembly - Detailed; Control Top Reassembly; Ptt Reassembly - Motorola GP88s Service Manual

Radio Reassembly — Detailed
6.6

Control Top Disassembly

1. To remove the control top assembly, place a screwdriver next to the antenna boss, and pry it
against the top escutcheon. This will lift the top escutcheon away from the top of the front
housing.
2. Remove the control top seal and transmit light pipe.
7.0 Radio Reassembly — Detailed
7.1

Control Top Reassembly

1. Replace transmit light pipe and control top seal.
2. Peel off the liners from a new top escutcheon, and place it in the recess in the front cover.
Press the top escutcheon down uniformly.
7.2

PTT Reassembly

1. Put the PTT seal in the PTT bezel.
2. Place the bezel 'T' tab in the 'T' slot inside the front cover PTT opening. Slightly slide down
the bezel so that the two snaps can be aligned and inserted into the two rectangular slots.
3. Press the PTT assembly against the front cover opening.
NOTE Look inside the front cover to make sure the T-tab and snaps are fully engaged with the
front cover.
7.3

Speaker Reassembly

1. Align the notch in the speaker at the six o'clock position with the tab on the front cover.
2. Place the speaker retainer bracket into the hole on the top of the front cover, and bend the
retainer down to fit underneath the boss below the speaker.
4-11