Troubleshooting Problems - 3Com NBX Manual

Hide thumbs Also See for NBX:
Table of Contents

Advertisement

144
A
A: T
PPENDIX
ELEPHONE
Troubleshooting
Problems
Table 9 Possible Problems
Possible Problem
My telephone has no dial tone. The display
panel is blank.
My telephone has "locked up."
Callers cannot leave messages on my voice
mail.
When I park a call, the display panel shows
Park xtn in use, and the call returns to
my telephone.
When I dial 9 or 8 to access an outside line,
the display panel shows All Ports
Busy.
After I call another user in my organization,
I hear a tone but no ringing.
When I try to access the NBX NetSet
utility, I do not get a response after I type
the NBX system's IP address and press
Enter.
I am unable to log in to the NBX NetSet
utility.
I
M
NSTALLATION AND
AINTENANCE
Table 9
lists possible problems that you may encounter and the most
likely solutions. Where possible, each solution refers to the section in this
guide where you can find detailed information.
Suggested Solutions
Verify that the power cord is fully inserted in the correct connector
on the underside of the telephone. Use the strain relief tab to
prevent the cord from becoming unplugged.
Verify that each RJ45 cable is connected and that each cable is in
the proper connection.
Remove and add power to the telephone by unplugging the power
cord at the electric outlet and plugging it back in.
If the telephone is powered through a powered RJ45 cable, make
sure that power is applied to the cable at its source.
Your telephone has lost the connection to the system. Remove the
RJ45 cable from the jack, and then re-insert it into the jack.
Wait a few seconds. If the telephone still appears to be locked,
disconnect the electrical power for your telephone, and then plug it
back in.
Your mailbox may be full. Log in to your voice mailbox and delete
some messages.
Your telephone may be set up for Greeting Only Mailbox. Log in to
the NBX NetSet utility and go to NBX Voice Mail Settings >
Personal Greeting and clear the Greeting Only Mailbox
checkbox.
You have selected a Call Park extension that is already in use. Try
another Call Park extension. Your administrator can add additional
Call Park Extensions. For details, see
No outside lines are available. Try again in a few minutes.
The other user may have the Hands Free Active on Intercom feature
enabled. Begin speaking after you hear the tone.
Ask your administrator to verify the IP address that you typed into your
web browser.
You must set up your voice mail before you can use the NBX NetSet
utility. Press the Message button. The prompts guide you through the
setup. Then use your voice mail password to access the NBX NetSet
utility. See
Time"
in
"Setting Up Your Password and Voice Mail for the First
Chapter
1.
"Call Park"
in
Chapter
7.

Advertisement

Table of Contents
loading

Table of Contents