Important Safety Instructions - 3Com NBX Manual

140 A A: T
PPENDIX ELEPHONE
Important Safety
Instructions
I M
NSTALLATION AND AINTENANCE
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electrical shock, and injury
to persons, including the following:
Read and understand all instructions.
■
Follow all warnings and instructions marked on the product.
■
Unplug this product from the wall outlet before cleaning. Do not use
■
liquid cleaners or aerosol cleaners. Use a dry cloth for cleaning.
Do not use this product near water; for example, near a sink or in a
■
wet area.
Do not place this product on an unstable cart, stand, or table. The
■
telephone may fall, causing serious damage to the unit.
To protect the product from overheating, do not block or cover any
■
slots or openings in the base Unit. This product should never be placed
near or over a radiator or heat register. This product should not be
placed in a built-in installation unless proper ventilation is provided.
This product should be operated only from the type of power source
■
indicated on the marking label.
Do not allow anything to rest on the power cord. Do not place this
■
product where the cord could be damaged by persons walking on it.
Do not overload wall outlets and extension cords, as this can result in
■
the risk of fire or electrical shock.
Never put objects of any kind into this product through the base unit
■
slots, as they may touch dangerous voltage points or short out parts
that could result in a risk of fire or electric shock. Never spill liquid of
any kind on the product.
To reduce the risk of electric shock, do not disassemble this product.
■
Contact qualified service personnel when service or repair work is
required. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly can cause electric shock
when the appliance is subsequently used.
Unplug this product from the wall outlet and refer servicing to
■
qualified service personnel under the following conditions:
When the power supply cord is damaged or frayed.
■
If liquid has been spilled on the product.
■
If the product has been exposed to rain or water.
■