Setting Or Changing A Program - DIG LEIT RC2ET Operating Instructions Manual

YES/NO CONNECT CONNECT
10:00 10:00 10:00
UPLOADING
MANUAL RUN MANUAL TEMP CONNECT
10:00 10:00 10:00
ARE YOU SURE?
DOWNLOADING CONNECTED
YES/NO CONNECT CONNECT
10:00 10:00
c. Global Stop
Stops irrigation of all controllers with the same CLIENT ID within range of the
handset for a selected number of days.
In the CONTROLLER MENU screen press
MANUAL RUN EXIT
Press and MANUAL RUN MENU screen appears. Press
GLOBAL STOP icon. Press and the GLOBAL STOP screen with a STOP FOR
01 DAYS appears with 01 blinking. Press
days to stop irrigation. Press to connect. ARE YOU SURE? screen appears
10:00
with the RADIO UPLINK highlighted. Press
The signal may take a few seconds. Within the handset range, all the LEIT-2ET
controllers with the same CLIENT ID will stop for the number of days selected.
Then the controller MANUAL RUN MENU will appear. Exit the screen to the
CONTROLLER MENU.
CONTROLLER MENU
10:00 10:00 10:00
MANUAL RUN GLOBAL STOP
10:00
CONNECTED
TURN OFF
SKIP TO NEXT
CONNECT MANUAL TEST
10:00
10:00
CONNECTED
00:00
00:00
MANUAL TEMP
CONNECT
10:00
UPDATE
SUCCESSFUL
CONNECT
and highlight MANUAL RUN icon.
and highlight
or to select the number of
, and CONNECTING will appear.
10:00 10:00
ARE YOU SURE? CONNECTED
STOP FOR
XX DAYS
YES/NO CONNECT CONNECT
20

4.1 Setting or Changing a Program

The Program feature allows the user to review, change or set a schedule
with up to two (2) separate programs for each station. Each valve can be
programmed with odd, even, or up to every thirty (30) days. Each program
has up to four (4) individual start times per day with durations of up to five
(5) hours and fifty-nine (59) minutes in one (1) minute increments for each
valve. On each program the second valve can be attached to the first valve if
hydraulic limitations are not exceeded. At the end of the program the handset
also displays the next time a program will operate.
In CONTROLLER MENU screen press
Press to enter PROGRAM MENU screen. To program, press
and highlight PROGRAM A icon. Press
communication, CONNECTED appears momentarily and then, SELECT DAYS
screen and PROGRAM A appears with SELECT DAYS blinking. Use the
programming steps below to make any adjustments, as needed. Repeat the
steps for PROGRAM B or exit the PROGRAM MENU.
SELECT DAYS: Set the day of the week.
In each of the two programs the following options are available:
MTWTFSS: Select specific day(s) of the week with a icon above the day.
EVERY: Enables the stations to operate from once a day to once every 30 days.
ODD: Every odd number of days.
EVEN: Every even number of days.
In SELECT DAYS screen, press or
available. If ODD DAYS or EVEN DAYS are chosen, press
cyclical days are required, press . The 01 appears blinking. Press
to select the number of days needed. If SELECT DAYS (MTWTHSS) is
chosen, press the to select. The underscore above (M) for Monday will
and highlight the PROGRAM icon.
then
to connect. After establishing
and select one of the options
to select. If
or
21