Table of Contents
Advertisement
4.1 Setting or Changing a Program
The Program feature allows the user to review, change or set a schedule
with up to two (2) separate programs for each station. Each valve can be
programmed with odd, even, or up to every thirty (30) days. Each program
has up to four (4) individual start times per day with durations of up to five
(5) hours and fifty-nine (59) minutes in one (1) minute increments for each
valve. On each program the second valve can be attached to the first valve if
hydraulic limitations are not exceeded. At the end of the program the handset
also displays the next time a program will operate.
In CONTROLLER MENU screen press
Press
to enter PROGRAM MENU screen. To program, press
and highlight PROGRAM A icon. Press
communication, CONNECTED appears momentarily and then, SELECT DAYS
screen and PROGRAM A appears with SELECT DAYS blinking. Use the
programming steps below to make any adjustments, as needed. Repeat the
steps for PROGRAM B or exit the PROGRAM MENU.
SELECT DAYS: Set the day of the week.
In each of the two programs the following options are available:
MTWTFSS: Select specific day(s) of the week with a icon above the day.
EVERY: Enables the stations to operate from once a day to once every 30 days.
ODD: Every odd number of days.
EVEN: Every even number of days.
In SELECT DAYS screen, press
available. If ODD DAYS or EVEN DAYS are chosen, press
cyclical days are required, press
to select the number of days needed. If SELECT DAYS (MTWTHSS) is
chosen, press the
or
. The 01 appears blinking. Press
to select. The underscore above (M) for Monday will
21
and highlight the PROGRAM icon.
to connect. After establishing
and select one of the options
then
to select. If
or
Advertisement
Table of Contents
