Table of Contents
Advertisement
8.0 Programming Problems:
The valves will turn on using the MANUAL RUN feature but will not water automatically.
Check the following:
1. The RAIN STOP is active. To reactivate the program schedule, go into the SETUP
MENU screen, select RAIN STOP setting to 00 and cancel RAIN STOP (see page 25).
2. Check the date and time for the controller in CURRENT STATUS to make sure that
the time and date's are the same as the handset.
3. No programming schedules have been entered yet. In CONTROLLER MENU, select
program and set up a schedule.
4. The programmed runtime of the station is set to "0" duration. Go into CONTROLLER
MENU, select the program and set up a runtime.
5. A sensor is hooked up to the system and it is inhibiting irrigation.
6. If the valves operate correctly in a manual run but not in a scheduled program, check
that the following settings are correct:
a. Review the programs
b. Month stop - turn off MONTH OFF and Month Selection screens
c. Scheduled start times, runtimes per program set correctly
7. If a new program starts before the old program has completed it will be stacked to
commence later.
8. Make sure there is enough time between the programs and/or start times to meet
your watering time in Budget (up to 200% possible).
There is no communication between the handset and the controllers.
Solution:
1) Check that the controller PVM (solar) panel is not covered. If it has been covered for
an extended period, the controller time will reset.
8.1 The Password has been changed or forgotten
Please call DIG Customer Service with the serial number of the
controller and handset.
46
9.
PROGRAMMING QUICK REFERENCE CHART
47
Advertisement
Table of Contents
