Jenn-Air Range Installation Manual page 7

Gas Supply Connections For Ranges With
Appliance Pressure Regulator
Located In The Bottom Of Range
TO CONNECT GAS SUPPLY TO 1/2² N.P.T. MALE INLET
TO CONNECT GAS SUPPLY TO 1/2² N.P.T. FEMALE INLET
FIGURE 7
WHEN THE INSTALLER
INSTALLATION OF THE APPLIANCE, LEAVE THE
APPLIANCE PRESSURE REGULATOR SHUT-OFF
VALVE IN THE "ON" POSITION.
*
The appliance pressure regulator on your range may
differ from this illustration.
CHECKING PRESSURE OF HOUSE PIPING
SYSTEM
1. The appliance and its individual shutoff valve must be
disconnected from the gas supply piping system during
any pressure testing of that system at test pressures in
excess of 1/2 lbs./sq. in. (3.5 kPa) (13.8 in. water
column).
2. The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
HAS COMPLETED
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
1/2 lbs./sq. in. (3.5 kPa) (13.8 in. water column).
RANGE ADJUSTMENTS
Top Section - Electric Ignition
To operate, push and turn top burner knob to the LITE
position. The top burner will light. To turn OFF spark after
the top burner has ignited turn knob to HI setting.
Air Shutter - Oven Burner
a. The approximate length of the flame of oven burner is
a 1/2 inch distinct inner blue flame, figure 7.
b. Oven burner flame can be checked as follows:
1. Yellow flame on burner - open burner air shutter
to the widest opening that will not cause the flame
to lift or blow off the burner when cold. (See #2 on
figure 8).
2. Distinct blue flame but lifting - close burner air
shutter to the point where it will not cause the
flame to lift or blow off the burner when cold. (See
#2 on figure 8).
c. The oven burner air shutter adjustment is the same on
ranges with a gas pilot or electric ignition.
-7-
FIGURE 8
FIGURE 9