Installation - HighSecLabs K202B User Manual

Installation

Step 1 Connecting the Console devices to the Switch
See figures in page 11 above for connector locations.
Note: for installation instructions with Remote Fiber Extender
(RFE) – refer to the RFE product User Manual.
Connect the user display.
•
Note: K202B - If user display is only VGA
- Verify that all computers are having either VGA or DVI-I
display output.
- Use supplied DVI to VGA adapter.
Connect the user console keyboard (USB).
•
Connect the user console mouse (USB).
•
Note: If USB mouse is connected to the USB keyboard port or if USB
keyboard is connected to the USB mouse port it would not work!
Note: Keyboards with integrated USB hub, card-reader, storage
device or multimedia extension will be either not supported at all or
only keyboard function will be operating.
Connect the user headphones or amplified speakers to the
•
switch audio output jack.
Note: In any case do not connect a microphone to the switch audio
output port.
K202B/D Secure KVM Switch User Manual
Section 3 - Installation
Step 2 Connecting the Computers
Connect the two computers to the Secure KVM switch through the
following steps:
Connect each computer with KVM cable (DVI and USB or VGA
•
and USB cables – for details on cables see page 6). USB cable
can be connected to any free USB port in the computer.
Note: If computer is having more than one video output connector
– first test for video output availability by connecting a display
directly to that port.
Note: Note: The USB cable must be connected directly to a free USB
port on the computer, with no USB hubs or other devices in
between.
Connect an audio cable (CPN05490) to the computer audio
•
output (lime green color) or line output (blue color) jacks.
Step 3 Power up
Power up user display. Select proper input if applicable (VGA or
•
DVI-D).
Power up the Secure KVM Switch by connecting the power. The
•
display diagnostic LEDs should be solid green for a few seconds
after power up. This indicates the display EDID information has
been captured and secured. If the display diagnostic LED
remains blinking for longer than 10 seconds after power up,
refer to the Troubleshooting section of this user manual.
Power up the connected computers.
•
Note: When you power on your computers, the Switch emulates
both a mouse and keyboard on each port and allows your
computers to boot normally. The computer connected to port "1"
will be displayed on the user's display. Check to see that the
15