How To Operate - Oster Kitchen Center Recipes & Instructions

Oster kitchen center recipes & instructions
Table of Contents

Advertisement

HOW TO OPERATE

1. Assemble mixer/doughmaker
base (Fig. 1).
2. Always recheck the proper assembly of dough hooks
before kneading bread. If the dough hooks are not
properly placed in the correct sockets, the dough
will climb the dough hooks.
3. Add ingredients to bowl as instructed by recipe.
4. Press release latch and lower arm and beaters or
dough hooks gently into mixing bowl (Fig. 2).
5. Select proper speed by referring to MIXING GUIDE
on top of mixer/doughmaker arm. Turn Control Dial
to reach desired speed. Numbers on control panel
correspond with mixing speeds in MIXING GUIDE.
Due to varying consistencies of batters and doughs,
it may be necessary to adjust speed.
6. Push "ON" button and process ingredients for time
specified in each recipe. In normal use, unit should
never stall. If motor stalls, turn unit "OFF" and
check
recipe.
7. While mixing or kneading, use rubber spatula to
move dry ingredients from sides and bottom of bowl
into mixture. Guide bowl gently, if necessary.
6. Push "OFF" button if the motor needs to be stopped
for adding ingredients or scraping bowl. To start
motor again, push "ON" button.
9. When mixing or doughmaking is completed, push
"OFF" button.
10. Press release latch (Fig. 2) and lift arm to upright posi-
tion. Release pressure on release latch. To release
beaters or hooks, move ejector lever to side (Fig. 3).
DO NOT IMMERSE ARM OR TURNTABLE IN WATER. Beaters, dough hooks and
bowls are dishwasher safe. Dry beaters and dough hooks immediately after clean
ing. Do not tap beaters or dough hooks on side of bowl to remove dough.
Wipe mixer/doughmaker
The mixer/doughmaker
arm and turntable are permanently lubricated and neve
need oiling. Damaged beaters, dough hooks and broken bowls should be replaced
with genuine replacement parts. Other replacements may cause bowl breakage
during use. (Stainless steel bowls are not breakable, but if
necessary, use only genuine replacement parts.)
ANY SERVICE REQUIRED SHOULD BE PERFORMED BY AN AUTHORIZED
OSTER
SERVICE
FACILITY.
and mount on motor
CLEANING
arm and turntable with a soft, damp cloth to clean.
MAINTENANCE
Fig. 3
replacement bowls are

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents