Assembly - Oster Kitchen Center Recipes & Instructions

ASSEMBLY

1. Position TURNTABLE into correct socket on Motor
Base. The 2 inner sockets are for use with the small
Bowl. The socket toward the back of Motor Base is
used for small Bowl and Beaters. The socket to the
front on the Motor Base is for use with the Dough
Hooks. SEE DIAGRAMS ON MOTOR BASE. The
outer socket is designed for use with the large Bowl,
using either the Beaters or the Dough Hooks. SEE
DIAGRAMS ON MOTOR BASE.
2. On underside of Mixer Arm, locate four (4) sockets
and identifying label as shown.
To Insert Beaters:
Locate sockets identified by the symbol
Put the Beater with one groove in the socket identified
with one groove and snap into locked position. Put the
Beater with two grooves in the socket identified by
two grooves and snap into locked position.
To Insert Dough Hooks: Same manner as
Beaters except on side identified by the symbol
ALWAYS RECHECK THE PROPER ASSEMBLY OF
DOUGH HOOKS BEFORE KNEADING BREAD. IF
THE DOUGH HOOKS ARE NOT PROPERLY PLACED
IN THE CORRECT SOCKETS, THE DOUGH WILL
CLIMB THE DOUGH HOOKS.
NOTE: Do not insert Dough Hooks or Beaters into
Mixer Arm at the same time.
3. Mount Arm
and Release Latch and lowering onto pivot pins. Re-
lease Trigger and Latch. Arm should be securely
fastened. Trigger will snap out.
4. Press Release Latch on the underside of Mixer/
Doughmaker Arm, then raise Arm. Releasing pres-
sure on Latch will permit cams to automatically drop
into position and lock to support Arm in raised posi-
tion. CAUTION: Never place fingers between Arm
and Motor Base. If Arm should drop, injury could
result.
Base by pressing Trigger