Users In Canada - Canon imageRunner 1670F Facsimile Manual

Users in Canada

Preinstallation Requirements for Canon Facsimile Equipment
A. Location
Supply a suitable table, cabinet, or desk for the machine. See Chapter 7,
"Appendix," in the Reference Guide for specific dimensions and weight.
B. Telephone Line Requirements
1. Provide only a single-line touch-tone or rotary telephone set terminated with a
standard 4-pin modular telephone plug. (Touch-tone is recommended if
available in your area.)
2. Order a CA11A modular jack which should be installed by the telephone
company. If the CA11A jack is not present, installation cannot occur.
3. Order a normal business line from your telephone company's business
representative. The line should be a regular voice grade line or an equivalent
one. Use one line per machine.
DDD (Direct Distance Dial) line
-or-
IDDD (International Direct Distance Dial) line if you communicate overseas
NOTE
Canon recommends an individual line following industry standards, such as
2500 (Touch-Tone) or 500 (Rotary/Pulse Dial) telephones. A dedicated
extension off a PBX (Private Branch Exchange) unit without "Call Waiting"
can be used with your facsimile unit. Key telephone systems are not
recommended because they send non standard signals to individual
telephones for ringing and special codes, which may cause a facsimile
error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or
Duplex). It should be independent from copiers, heaters, air conditioners, or any
electric equipment that is thermostatically controlled. The rated value is 120 volts
and 15 amperes. The CA11A modular jack should be relatively close to the power
outlet to Facilitate installation.
xv