Sharp Zaurus SL-C3000 Instruction Manual page 67

my Zaurus SL-C3000 and SL-C3100
Setting up a bluetooth PAN (Personal Area Network)
A PAN allows you to access services on the other bluetooth enabled devices like on a small network
with TCP/IP connectivity. This requires that the other devices, usually bluetooth enabled computers,
provide services such as Samba, FTP, HTTP, Telnet, SSH/SCP, etc.
On your Zaurus do the following:
# su
# modprobe bnep
# pand --role PANU --service NAP --connect xx:xx:xx:xx:xx:xx --nodetach
(where xx:xx:xx:xx:xx:xx is the mac address of your Desktop PC or Laptop)
This will give your Zaurus an additional network interface called bnep0 if a successful connection
was established.
# ifconfig -a
You can then configure your PAN network like this:
# ifconfig bnep0 192.168.12.201
# route add default gw 192.168.12.10
To check the connection ping your desktop or laptop:
# ping 192.168.12.10
This assumes that you have a 192.168.12.0 private network and your PC or Laptop is
192.168.12.10
To terminate the connection just type:
# pand -K
67 of 212
http://www.users.on.net/~hluc/myzaurus/
16/09/2007 12:23