Sharp Zaurus SL-5500 Quick Start Manual

3
connector USB
port USB
PC
device. your
finds PC your that insure to installation
the of part this during On Powered is
Zaurus your that sure Make Important:
Software.
Zaurus the install to ready now are You
key). (Cancel key
On/Off the pressing by Zaurus the On Turn
Station Docking
the into Zaurus the slide and 5500
SL- the of cover Port I/O Sharp the Open
6
6
Zaurus the Docking
(EA-70) adapter AC
outlet AC To
jack adapter AC
Station Docking
8
8
USB Driver Installation - Continued
1. When the USB installation is completed you will be asked to Reboot your PC.
Depending on the Windows® Operating system you are using, the following screen may
vary.
After rebooting your PC resume your installation by. "Installing the Synchronization
Software"
10 10
Congratulations!
You are now ready to use your Zaurus SL-
5500 and Synchronization Software. On
the other side of this Quick Start Guide
Sheet, there is information about how to
use your Zaurus and software.
Page 4
Page
installed. are drivers TCP/IP and
Network the both until Wizard the Follow
device. the install
to want you if you notifying appear will
box dialog Wizard" Hardware New "Add
or Wizard" Hardware New "Found Either
computer.
your of port USB the into Station
Docking the of connector USB the Plug
drive. CD-ROM your into CD installation
Zaurus the insert and PC your on Turn
device. your finds PC your that insure
to installation the of part this during
Powered is Zaurus your that sure Make
Installation Driver USB
Station
Docking
2.
1.
cable
Station. Docking
the to adapter AC the Connect
adapter.
AC the from Zaurus the Disconnect
Station Docking
the to Power the
Connecting & Zaurus
the Disconnecting
9
9
Install the Synchronization
Software
On the installation CD select - Step. 3 "Installing
the Synchronization Software"
NOTE: You may only install one synchronization
software program on your PC. If you try to
install both software programs you will get an
error.
If you are a Microsoft® Outlook® user click on
this Icon to install the software
If you Don't use Outlook and want to install the
Qtopia Desktop Synchronization software click
this Icon to install the software.
When you are finished installing your
synchronization software you will be asked to
reboot your computer once again.
4.
the down holding
Home the see
Personal the with
3.
button.
finished When
(See passcode.
2.
for Passcode
1.
tap finished When
enter Zaurus,
On
the on tap finished
zone time
7 7
by Zaurus the
panel. screen
cross the on tap
screen. calibration
on tap appears,
Information
Entering & Screen
USB
outlet AC To
2.
adapter. AC the
1.
charging.
5 5
Quick Start Guide - Read This First
Congratulations on your new purchase of the Sharp Zaurus SL-5500!
The Zaurus SL-5500 is a new exciting PDA from Sharp with exceptional Personal
Information Management, Mobile Communications and Mobile Multimedia tools.
You must prepare your Zaurus SL-5500 before you install your Zaurus software. Please
follow this Quick Start Guide, which will walk you through the installation of your Zaurus.
This Quick Start Guide is for experienced users of PC's or handheld PDA's and is not
intended to be used in place of the manuals supplied with your Zaurus. If at any time you
are not sure how to setup your Zaurus, please refer to the Start-up Guide and Operation
Manual the came with your Zaurus.
1
1
Opening the Battery
Compartment Lid
1. On the back of the Zaurus, slide the battery
replacement switch to the "REPLACE BATTERY"
position.
2. Gently slide replacement battery compartment lid
to the right and remove it from the Zaurus.
2 Page
Key). (Cancel Key On/Off
by Zaurus your Off Turn 7.
screen.
will you setup Information
finished are you When 6.
Finished the on tap
details.) for Guide Start-up
a enter purposes, Security
a enter to want you If 5.
button. Next the on
Details. Personal your
the of keyboard the Using 4.
button. Next
When information.
appropriate the entering
of Time System the Set 3.
touch the calibrate to hairs
screen, calibration the At 2.
the to go to screen the
screen Welcome the After 1.
Personal
4
4
Welcome
adapter AC
connector
adapter AC
cord
power AC
jack adapter AC
capacity. full
attach you if even on turn not will power the
key). (Cancel key On/Off the pressing
is Zaurus the that indicating glow
Outlet. AC an
Zaurus. the
Adapter. AC the to
Power
2
2
Install the Lithium Ion Battery
1. Insert the battery on the ribbon tab making sure
that the triangle, plus (+) and minus (-) signs on the
battery match the markings on the inside of the
Zaurus.
2. Replace the battery compartment lid with the
ribbon tab inside.
3. Slide the battery replacement switch to the
"NORMAL OPERATION" position.
4. When using the battery for the first time make sure
you charge the unit for 24 hours.
Page 1
cord
power AC
adapter AC
its to battery the Charge
low, is level battery the • If
by Zaurus the On Turn 5.
to begin will LED Amber The 4.
into Cord Power AC the Plug 3.
to adapter AC the Connect 2.
Cord Power AC the Connect 1.
3 3
the Connecting
TINSE1281YCZZ PRINTED IN JAPAN