Service And Repairs; Battery Storage; Battery Care - Toro ProCore Processor Service Manual

Service and Repairs

NOTE: See the Briggs & Stratton Repair Manual for
4-cycle, V-twin Cylinder, OHV Head Engines for engine
electrical component repair information.

Battery Storage

If the machine will be stored for more than 30 days:
1. Remove the battery from the machine and charge it
fully (see Battery Service).
2. Either store battery on a shelf or on the machine.
3. Leave cables disconnected if the battery is stored on
the machine.

Battery Care

1. Battery electrolyte level must be properly main-
tained. The top of the battery must be kept clean. lf the
machine is stored in a location where temperatures are
extremely high, the battery will discharge more rapidly
than if the machine is stored in a location where temper-
atures are cool.
CAUTION
Wear safety goggles and rubber gloves when
working with electrolyte. Charge battery in a
well ventilated place so gasses produced
while charging can dissipate. Since the gases
are explosive, keep open flames and electrical
sparks away from the battery; do not smoke.
Nausea may result if the gases are inhaled. Un-
plug charger from electrical outlet before con-
necting or disconnecting charger leads to or
from battery posts.
IMPORTANT: Do not remove battery fill caps while
cleaning.
2. Check battery condition weekly or after every 50
hours of operation. Keep terminals and entire battery
case clean because a dirty battery will discharge slowly.
A. Clean battery by washing entire case with a solu-
tion of baking soda and water. Rinse with clear water.
B. Coat battery posts and cable connectors with
Battery Terminal Protector (Toro Part No. 107--0392)
or petroleum jelly to prevent corrosion.
Electrical System
4. Store battery in a cool atmosphere to avoid quick de-
terioration of the battery charge.
5. To help prevent the battery from freezing, make sure
it is fully charged (see Battery Service).
3. Battery cables must be tight on terminals to provide
good electrical contact.
Connecting battery cables to the wrong bat-
tery post could result in personal injury and/or
damage to the electrical system.
4. If corrosion occurs at battery terminals, disconnect
cables. Always disconnect negative (--) cable first.
Clean clamps and terminals separately. Reconnect
cables to battery with positive (+) cable first. Coat bat-
tery posts and cable connectors with Battery Terminal
Protector (Toro Part No. 107--0392) or petroleum jelly to
prevent corrosion.
5. Periodically (at least every 50 operating hours)
check battery electrolyte level. Check electrolyte level
every 30 days if machine is in storage.
6. Maintain battery cell level with distilled or demineral-
ized water. Do not fill battery cells above the fill line.
Page 5 - - 12
CAUTION
ProCore Processor