Hour Meter; Fuses - Toro ProCore Processor Service Manual

Hour Meter

The hour meter used on the machine records the
amount of time that the ignition switch is in the RUN posi-
tion.
Testing
1. Make sure that Processor ignition switch is in the
OFF position. Remove key from the ignition switch. Lo-
cate wire harness connector at rear of hour meter. Un-
plug harness connector from hour meter.
2. Connect the positive (+) terminal of a 12 VDC source
to the positive (+) terminal of the hour meter.
3. Connect the negative (--) terminal of the voltage
source to the other terminal of the hour meter.
4. The hour meter should move 1/10 of an hour in six
minutes.
5. Disconnect the voltage source from the hour meter.
6. Replace the hour meter if necessary.
7. Connect wire harness connector to hour meter.

Fuses

The ProCore Processor uses two (2) fuses for circuit
protection. The fuse holders for these fuses are located
next to the engine (Fig. 12).
Main Fuse (25 Amp): Protects main power supply.
The main fuse can be identified by an orange and a
pink harness wire.
Run Fuse (10 Amp): Protects power supply to run
machine components (fuel solenoid, hour meter and
optional hitch coil). The run fuse can be identified by
a green and a gray harness wire.
Testing
Make sure that Processor ignition switch is in the OFF
position. Remove key from the ignition switch. Remove
fuse from the fuse holder for testing. Fuse should have
continuity between fuse terminals.
ProCore Processor
Hobbs
QUARTZ
0 0 0 0 1
HOURS
FRONT
1. Main fuse
Page 5 - - 9
+
1
10
BACK
Figure 11
2
1
Figure 12
2. Run fuse
Electrical System