Charging The Battery; Charger Status Indicator Lights; Sprayer Status Indicator - Graco 258850 Operation Manual

Charging the Battery

Charging the Battery
Batteries may leak, explode, cause burns or cause an
explosion if mishandled.
Batteries are initially 50% charges to provide optimum
battery life and require charging before first use. It takes
approximately 45 minutes to charge a dead battery to
80%, at which point it can be used.It will take approxi-
mately 75 minutes to fully charge a dead battery.
1. Slide battery into charger as shown (light will turn on
within 5 seconds).

Charger Status Indicator Lights

Label Appearance
Solid green light
Flashing green light
Flashing red light
Solid red light

Sprayer Status Indicator

Light
NOTE: The indicator light is only visible when sprayer trigger is engaged. You must squeeze and hold the trigger to
see the Sprayer Status Indicator.
3A1204E
ti14990
Indicates a full charge. Use the battery or leave it in the charger.
The automatic Maintenance Mode holds the batteries at full charge.
Battery is charging, indicates 80% charge.
Battery can be used.
Battery is charging, indicates less than 80% charge.
Do NOT use battery.
Battery is too hot or too cold to charge and must cool or warm up before
charging. Leave battery in charger.
Appearance
No light
Solid red
Flashing red
NOTE: Batteries can remain in the charger, which
automatically switches to maintenance mode. It is not
recommended to store the battery in the charger for
longer than one week.
To reduce the risk of electric shock, only use Graco
batteries with the Graco charger. Do not insert any
foreign objects into the adapter cup.
NOTE: The amount sprayed with each battery varies
depending on material, tip size, battery charge, and bat-
tery temperature. 1 battery fully charged will spray
approximately 1 gallon when using the 515 tip with latex
paint. You will get less when using a smaller tip or thin-
ner material.
NOTE: The charger comes with a power cord adapter
connected to the power cord. To switch from the AS3112
connector to the 2-pin Euro CEE7 connector, pull off the
adapter.
Do not place a wet battery in the charger. Damage to
equipment will occur.
Description
Normal operation.
Battery is low on power and needs to be charged, or battery
is too cold and must warm up prior to spraying.
Battery temperature is too high, or tip is clogged.
See Troubleshooting, page 21.
NOTICE
Description
7