Cleaning Sprayer Exterior; Tips; Storage - Graco 258850 Operation Manual

Cleaning Sprayer Exterior

• Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid.
Do NOT submerge the sprayer.

Tips

• Tips will require replacement depending on
abrasiveness of paint.
• Do not spray with worn tip. See Troubleshooting,
page 21.

Storage

NOTICE
Failure to store with sprayer with Pump Armor will
result in operational problems the next time you spray.
Always circulate Pump Armor through the sprayer
after cleaning. Water left in the sprayer will corrode
and damage the pump.
1. Dilute 4 oz. of Pump Armor with an additional 4 oz.
of water in material cup.
ti15442a
16
4 oz
2. Thread cup into sprayer, put prime/relief valve to UP
position and squeeze sprayer trigger for approxi-
mately 10 seconds.
ti14999a
3. Reverse spray tip to UNCLOG position, put
prime/relief valve DOWN to spray position, and aim
sprayer into waste area. Pull trigger for 1-2 seconds.
ti14991a
4. Properly dispose of used Pump Armor mixture from
material cup and rinse cup with water.
5. Store sprayer indoors in a cool, dry place. Store in
an upright position only.
NOTE: For prolonged battery life, lithium ion batter-
ies should be stored at half charge in an environ-
ment below 90° F (32° C).
ti15425a
ti15001a
ti15438a
3A1204E
Storage
ti15418a