Error Code Failure System - Baumatic BDWF670SL User Manual

Error code failure system

If your appliance senses that it is not operating correctly, then an error
code may appear in the display window.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
E1
o Longer than expected fill time or drain time.
Check the water pressure of your mains water supply.
Clean the mesh filter that sits in the inlet hose.
Ensure that the inlet hose is not kinked or crushed.
Make sure the water tap that the machine is connected to is turned
on fully.
Check that the outlet hose is not kinked or crushed and that it's
positioned correctly (as per the installation instructions).
E4
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E9
o A button has been pressed and held for more than 30 seconds.
Release the hold on the button.
Sensor malfunction
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Switch the appliance back on using the ON/OFF button.
o Wait for a 5 seconds before attempting to set a wash program,
using the program selection buttons.
IMPORTANT: If any other fault code appears in the
display window, you should not attempt to clear it yourself
and contact the Customer Care Department.
ANY MAINTAINEANCE ON THE
32