Baumatic BDWF670SL User Manual page 35

The filter assembly is
not clean or correctly
fitted. This may cause
the spray arm jets to get
blocked also.
Cloudiness on Combination of soft
glassware. water and too much
detergent.
Black or grey Aluminium utensils have
marks on rubbed against dishes.
dishes.
Detergent is Dishes are blocking the
left in the detergent dispenser.
dispenser.
The dishes are Improper loading.
not drying.
Too little rinse-aid was
used.
Dishes are removed too
soon.
Wrong program was
selected.
Use of cutlery with a
low-quality coating.
Clean or fit the filter assembly
correctly.
Clean the spray arms jets by
following the relevant
instructions.
Use less detergent if you have
soft water and select the GLASS
cycle to get them clean.
Use a mild abrasive cleaner to
eliminate those marks.
Re-load the dishes properly.
Load the baskets as suggested in
the relevant instructions.
Increase the amount of rinse-aid
or refill the rinse-aid dispenser.
Do not empty your dishwasher
immediately after washing. Open
the door slightly so that the
steam can escape.
Begin unloading the dishwasher
only once the dishes are barely
warm to the touch.
Empty the lower basket first to
prevent water from dropping off
dishes in the upper basket.
Some programs don't feature a
drying section. Refer to the
program table to select a more
appropriate program.
Water drainage is more difficult
with these items so cutlery or
dishes of this kind are not
suitable for washing in the
dishwasher.
35