Cleaning The Door; Error Code Failure System - Baumatic BDWI635 Instruction Manual

Cleaning the door

o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.

Error code failure system

The following error codes can possibly be remedied by the customer
and the maintenance steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
CODE MEANING
E1 Door open
E2 Water inlet
E3 Water drainage
E4 Temperature sensor
E5 Overflow / leakage
E6 Water leakage
E7 Heating element
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING THE
ADVICE ON THE FOLLOWING PAGES AND CLEARING THE FAULT
CODE YOU SHOULD TURN OFF THE APPLIANCE. DISCONNECT
THE APPLIANCE FROM YOUR MAINS SUPPLY AND THEN
ARRANGE FOR AN ENGINEER TO ATTEND THE APPLIANCE. YOU
SHOULD CONTACT THE CUSTOMER CARE DEPARTMENT.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then they will not complete a
repair.
o To clean the edge around the outside of
the door, you should use a soft, damp
cloth only.
o To prevent water from penetrating the
door lock or electrical components, DO
NOT use a spray cleaner of any kind.
ANY MAINTAINEANCE
The door is open when the
dishwasher is operating
Water inlet malfunction
Water drainage malfunction
Temperature sensor malfunction
Overflow / water leakage occurs
Water leakage occurs
ON
POSSIBLE CAUSES
Abnormal heating
THE
26