Table of Contents
Advertisement
o It is perfectly normal for a small amount of water to come out of
the salt container, whilst you are filling it with salt. This does not
mean that the container is filled with the correct amount of salt.
o Refit and fully tighten the salt container cap.
o The salt required warning light will go out soon after
should follow the filling with dishwasher salt procedure again.
o After filling the dishwasher with salt, it is recommended that you
run a RAPID program with no dishes loaded into the appliance to
remove any salt deposits which may have gotten into the
dishwasher interior.
o IMPORTANT: You do not need to pour 1 litre of water into
the container when you subsequently fill the water
softener with salt.
Setting the water softener level
It is possible to regulate the amount of salt that the water softener will
release during a wash cycle. The water softener should be set to a
level that is appropriate for the hardness of your water (please refer to
the table below).
WATER HARDNESS
°dH
°fH
°Clarke
0-5
0-9
0-6
6-11
10-20
7-14
12-14
21-30
15-21
18-22
31-40
22-28
23-34
41-60
29-42
35-55
61-98
43-69
To alter the amount of salt that is released by the water softener, you
should:-
o Switch on the appliance by pressing the ON/OFF button (1).
o Press and hold the start/pause button (6) for about 5 seconds to
enter the water softener setting mode. This must be done within
60 seconds of turning the appliance on.
o Use the start/pause button (6) repeatedly to scroll through the
selector options.
you have filled the salt container with salt. When the
salt indicator neon lights on the control panel, then you
Selector
Mmol/l
option
0-0.94
H1
1.0-2.0
H2
2.1-3.0
H3
3.1-4.0
H4
4.1-6.0
H5
6.1-9.8
H6
Salt
consumption
(cycles/1kg)
(gram/cycle)
0
/
20
60
30
50
40
40
50
30
60
20
Usage
13
Hide quick links:
Advertisement
Table of Contents
