Error Code Failure System - Baumatic BD696SS Instruction Manual

Error code failure system

If your appliance senses that it is not operating correctly, then an error
code may appear on the LED display and/or the warning icon (I) may
light.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
E0
o Insufficient amount of water in the dishwasher.
Check that the water tap is fully open.
Check that the filter in the inlet hose is not clogged.
Check that the inlet hose is not kinked or crushed.
E1
o No water.
Check that the water tap is fully open.
Check that the filter in the inlet hose is not clogged.
Check that the inlet hose is not kinked or crushed.
E2
o The dishwasher does not drain.
Check that the drain hose is not kinked or crushed.
Check that the drain hose is not blocked.
Check that the filter system inside the dishwasher is not blocked.
EA
o The machine was not able to fill with water.
Check that the drain hose is not kinked or crushed.
Check that the drain hose is not blocked.
Check that the filter system inside the dishwasher is not blocked.
Insufficient water pressure.
Ec
o Insufficient amount of water in the dishwasher
Check that no bowls have overturned inside the dishwasher.
Ed
o The door is not locked correctly
Check that the door is closed
Open and close the door.
After taking the necessary action to clear the fault code, you should
switch the machine off using the ON/OFF key (A). Wait for a few
seconds before switching the machine back on again.
ANY MAINTAINEANCE ON THE
33