Using Phone Filters - Zoom X5 User Manual

1 1 1 1
Go to the X5's Advanced Settings page, and click WAN
Settings.
2 2 2 2
To set the X5 for DHCP, select the DHCP client enable
box. Leave the Host Name field blank.
To Set the X5 for Static IP Addressing, enter the static
IP address and subnet mask assigned to you by your
service provider.
4 4 4 4
Do not change any other fields!
5 5 5 5
Click Save Changes, then Write Settings to Flash and
Reboot, and finally Confirm.
6 6 6 6
Return to the Basic Setup menu by clicking the Basic
Setup icon at the top of the X5's page, and resume
where you left off (either Step 4 on page 11 or Step 6 on
page 13).

1.4 Using Phone Filters

You should use a filter with each device—phone, fax machine,
analog modem, etc.—that is sharing the DSL-enabled line, because
this prevents the device from receiving noise when the DSL
modem is on. For all other devices on the DSL-enabled line, plug
the device's phone cord into the filter's PHONE end, and plug the
filter's LINE end into the wall jack. Some X5 models come with
filters, and more can be purchased from a retailer or service
provider.
Now that your modem is installed and appropriate filters are
attached, you're done. Enjoy using the X5.
The remainder of this manual contains information intended for
users looking for expanded capabilities or for future reference—for
example, there are chapters on Advanced Setup Options and
System Administration. Refer to the Table of Contents for
guidance.
14 X5 ADSL Modem User's Manual