Outside Air Kit Installation - Jøtul F50 TL Rangeley Installation And Operating Instructions Manual

139262 Rev_A 11/1/2010
Main Manifold
4" Duct Collar
Figure 22. Outside Air Kit parts identification and orientation.
7.2 Outside Air Kit 157320
Contents:
• Front Manifold • Main Manifold
• Outside Air Bottom Heat Shield
• 4" Duct Collar • M6 Hex Nuts, (6)
• #8 x 12 mm Sheet Metal Screws, (8)
You will need to acquire the following additional compo-
nents available at any hardware supplier:
• Exterior Air Inlet Cover
• Rodent Screen
The exterior air inlet should not be installed at a level
higher than the stove bottom.
1. Assembly will be easier with the Ash Door removed.
Release the cotter pin to remove the hinge pin.
2. Orient the Front Manifold Panel as shown in figs. 22 and
23. Set it in place above the ash housing between the
front legs of the stove.
3. Attach the Main Manifold to the four studs on the stove
bottom and the two studs on the Front Manifold using
the six hex head nuts provided.
4. Attach the Outside Air Bottom Heat Shield to the bot-
tom of the Main Manifold using four #8 x 12 mm sheet
metal screws.
5. Attach the Duct Collar to the Main Manifold using four
#8 x 12 mm sheet metal screws.
6. Connect the outside air duct, ( not provided ) to the col-
lar using a duct clamp.
22
• 4" Duct
• 4" Duct Clamps, 2
#8 x 12 mm Sheet Metal Screws
Outside Air Bottom Heat Shield
FRONT MANIFOLD PANEL
Figure 23. Front Manifold placement.
Figure 24. Final Assembly.
Front Manifold
M6 Hex Nuts,