Outside Air Kit Installation; Short Leg Installation - Jøtul Greenville F 45 V2 Installation And Operating Instructions Manual

7.2 Outside Air Kit 157637
Contents:
• Outside Air Manifold
Tools Required:
• 10 mm and 1/4 " socket drivers
• safety glasses
• work gloves
You will need to acquire the following additional components
available at any hardware supplier
• Exterior Air Inlet Cover
• 4" Aluminum Duct
• Rodent Screen
• 4" Duct Clamps, 2
The exterior air inlet should not be installed at a level higher than
the stove bottom.
1. Remove Bottom Heat Shield: Use the 10 mm socket driver or
wrench to remove the four nuts and the Bottom Heat Shield
from the studs in the stove bottom as shown in fig. 25. Also
remove the four remaining spacer nuts from the studs.
2. Attach the Outside Air Manifold directly to the stove bottom
using four of the nuts previously removed.
3. Use pliers to remove the air inlet cut-out from the bottom heat
shield.
4. Attach the bottom heat shield to the outside air manifold
using four sheet metal screws from the Outside Air Kit.
If the bottom heat shield will not be used, install the sheet
metal screws supplied with the outside air kit to plug the
associated holes in the manifold.
7.3 Short Leg Kit 157636
Approved for use only in fireplace hearth mount
(existing masonry fireplace) installations.
Contents:
4 1/4" Steel Legs, (4)
Tools Required:
• 13 mm wrench or socket/ratchet
• work gloves
DO NOT LIFT THE STOVE UP BY THE ASH LIP.
1. Have an assistant tilt the stove up on one side
enough to remove the cast iron legs. Fully remove
the nuts from the leg studs.
2. Engage the steel leg with the mounting stud. Be
certain the two locating tabs on each leg seat with
the corner pockets in the stove bottom. Tighten
the nuts and carefully set the stove back down.
Remove four nuts and use
to attach the manifold.
Sheet metal
Figure 25. Outside Air Adaptor installation.
Figure 26.

Short Leg installation

Tab Pockets
139967 F 45 V2 3/20
Manifold
screws
Locating Tab
23