To Cancel The Stay Zones; Buzz Zones; To Program Buzz Zones - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL
4. Repeat step 2 until all stay zones are selected.
5. Press the [#] key to exit the stay zone programming mode.

12.2 To Cancel the Stay Zones

If an area programmed as a STAY zone will no longer be violated
during STAY arming, then the STAY status of such a zone should be
cancelled. This will allow the system to protect that area during a stay
arm cycle.
1. Ensure that the READY indicator is illuminated.
2. Hold down the [3] key until the keypad buzzer sounds. The
AWAY indicator will flash to show that the panel is in the Stay
Zone programming mode.
3. Press the [
NUMBER
cancel followed by the [! ! ! ! ! ] key.
4. The relevant zone indicator will extinguish.
5. Press the [#] key to exit the stay zone programming mode.
NOTE:
The system will automatically exit this mode after 60 seconds.

13. Buzz Zones

Buzz zones are used when Stay arming. When triggered, buzz zones
will cause the keypad buzzer to sound for a period of 30 seconds
during which time a valid user code must be entered. If a valid user
code is not entered during this period the system will register an
alarm condition. It is advisable to program Buzz zones if you are likely
to accidentally trigger these zones or if you have pets.
This feature helps prevent unnecessary false alarms

13.1To Program Buzz Zones

1. Ensure the READY indicator is illuminated.
22 IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
[
3] + [ZONE NUMBER] + [! ! ! ! ! ]+ [#]
] corresponding to the STAY zone you wish to
[4] + [ZONE NUMBER] + [! ! ! ! ! ] + [#]