To Un-Bypass A Zone; Disarming The System; Disarming With A User Code - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL
is now bypassed.
4. Repeat steps 1 and 2 to bypass any other zones.
NOTE:
Some zones may be programmed to function in a manner which does
not permit bypassing e.g. Panic zones.

6.2 To Un-Bypass a Zone

1. Press the [! ! ! ! ! ] key.
2. Press the number corresponding to the currently bypassed zone
3. The zone indicator will extinguish - the zone is now active.

7. Disarming the System

7.1 Disarming with a User Code

To disarm the system, enter a valid [ USER CODE ] before the expiry of
the entry delay. Although not essential, it is recommended that the [#]
key be pressed before entering a user code as this clears any
unintended key entries.
!
Enter the premises through a designated entry/exit door. Enter-
ing via any other route will cause an alarm.
!
As soon as the entry/exit zone is violated i.e. the door has been
opened, the entry delay begins.
!
The keypad buzzer will sound for the duration of the entry period
to indicate that a valid user code is required.
!
If the ARMED indicator remains illuminated, an error was made
while entering the user code, press the [#] key and re-enter the
code.
!
Once the system disarms, the ARMED indicator will extinguish
and the keypad buzzer will stop sounding.
!
If no valid user code has been entered by the end of the entry
delay period, an alarm condition will be registered.
IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
[! ! ! ! ! ] + [ZONE NUMBER]
[#] + [USER CODE]
15