Maids Code; Stay Zones; To Program Stay Zones - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL
11.3 Domestic Workers Code
The domestic workers code (user 14) may be used to limit access to
the premises. The maids code will only disarm the system if the same
code was used for arming. If armed with a code other than a domestic
workers code, the system will view an attempt to disarm with the
domestic workers code as an invalid entry. Any valid user code will
disarm the system if it has been armed with the domestic workers
code.
EXAMPLE:
If a domestic worker is expected on a Monday, arming the system on
a Monday morning using the domestic workers code will allow the
domestic worker to disarm the system. On days that any other user
code (i.e. not a domestic workers code) has been used to arm the
system entering the domestic workers code will not disarm the
system.

12. Stay Zones

Stay zones are those zones which are bypassed automatically when
the system is STAY ARMED . To avoid triggering the alarm, zones
such as bedrooms, or other areas which require access, must be
bypassed. Stay zones need only be programmed once. Each time the
system is armed in the stay mode the preselected stay zones will be
bypassed automatically.

12.1 To Program Stay Zones

1. Hold down the [3] key until the keypad buzzer sounds. The
AWAY indicator will flash to show that the panel is in the Stay
Zone programming mode.
2. Press the [
NUMBER
zone followed by the [! ! ! ! ! ] key.
STAY
3. The relevant zone indicator will illuminate. (Buzz zones will be
shown by flashing indicators. See Section 13. A Buzz zone
cannot be selected as a Stay zone; the Buzz status must be
cleared first.)
IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
[
3] + [ZONE NUMBER] + [! ! ! ! ! ] + [#]
] corresponding to the zone you wish to be a
21