Arming With Entry/ Exit Or Follower Zones Violated; Forced Arming; Zone Bypassing; To Bypass A Zone - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL

5.8 Arming with Entry/ exit or Follower Zones Violated

The system can be programmed to arm even if the entry/ exit or
follower zones are violated. Follow the normal arming procedures i.e.
Enter a valid [
USER CODE
door.

5.9 Forced Arming

If so programmed, the panel can be armed even if there are violated
zones. This means that a monitored window can be left open or other
zones can be violated and the panel will still arm. If the violated zone is
then cleared, the panel will resume monitoring the zone, hence
causing an alarm condition or initiation of entry delay, as appropriate, if
violated.

6. Zone Bypassing

!
The term BYPASS is used to describe a zone that has been de-
activated; i.e. violation of a bypassed zone will not cause an
alarm.
!
It is used when:
!
access is needed to part of the protected area while the
system is armed.
!
Zones cannot be bypassed once the system is armed.
!
Bypassed zones are automatically cancelled each time the
system is disarmed and must be re-bypassed before the next
arming.

6.1 To Bypass a Zone

1. Press the [! ! ! ! ! ] key (while bypassing zones, violated zones will be
flashing).
2. Press the number corresponding to the zone you need to by-
pass e.g. the [2] key if you wish to bypass zone 2.
3. The relevant zone indicator will illuminate to indicate that the zone
14 IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
], but it is not necessary to close the front
[! ! ! ! ! ] + [ZONE NUMBER]