To Disarm With A Key-Switch Or Remote Control; Emergency Situations; Fire Alarm - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL
!
If the entry period is too short, have your installer change the
entry delay period.
!
If four incorrect user codes are entered consecutively while either
arming or disarming the system, the keypad will be non-
responsive for 30 seconds. Your monitoring company will also be
notified on a keypad tamper.
NOTE:
If the ARMED indicator is flashing upon entry, there has been a
violation. The intruder may still be inside! Call for assistance.
:
NOTE
If a strobe (or flashing light) has been installed and an alarm condition
is registered the light will continue flashing after the siren has stopped
sounding. Entering a valid [USER CODE] will cancel the strobe.

7.2 To Disarm with a Key-Switch or Remote Control

1. Press the remote button or twist and release the key-switch.
2. The system will disarm and the remote indicator (if installed) will
extinguish.
3. If programmed to do so, the siren will sound briefly - verify with
your installer.

8. Emergency Situations

8.1 Fire Alarm

(Hold down the key until the keypad buzzer sounds)
!
If the [F] key is held down until the keypad beeps (approximately
1 second) a FIRE ALARM condition will be activated.
!
The FIRE ALARM CONDITION
detector connected to an appropriately programmed zone.
!
The siren will sound and the FIRE REPORTING CODE will be
transmitted to the monitoring company.
!
To silence the siren enter a 4 digit [
stop sounding after 10 minutes if no user code is entered.
16 IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
[F]
can also be triggered by a smoke
USER CODE
]. The siren will