To Cancel The Stay Zones; Buzz Zones; To Program Buzz Zones; Ids 805 User Manual 700-266-01C Issued March - Inhep Digital Security IDS 805 User Manual

Hide thumbs

Table Of Contents

Table of Contents

12.2

If an area programmed as a STAY zone will no longer be violated during STAY arming, then the STAY

status of such a zone should be cancelled. This will allow the system to protect that area during a stay

arm cycle.

Hold down the [3] key until the keypad buzzer sounds. The AWAY indicator will flash to show that

the panel is in the Stay zone programming mode.

Press the [NUMBER] corresponding to the STAY zone you wish to cancel.

The relevant zone indicator will turn off.

Repeat step 2 until all stay zones are selected.

Press the [#] key to exit the Stay zone programming mode.

NOTE:

The system will automatically exit this mode after 60 seconds.

13.

Buzz zones are used when Stay arming. When triggered, buzz zones will cause the keypad buzzer to

sound for a period of 30 seconds during which time a valid user code must be entered. If a valid user

code is not entered during this period, the system will register an alarm condition. It is advisable to

program Buzz zones if you are likely to accidentally trigger these zones or if you have pets.

This feature helps prevent unnecessary false alarms.

NOTE:

Instant zones, such as panic zones, cannot be selected.

13.1

Hold down the [4] key until the keypad buzzer sounds. The AWAY indicator will flash to show that

the panel is armed in the Buzz zone programming mode.

Press the [NUMBER] corresponding to the zone you wish to be a Buzz zone.

The lit zone indicator will show the relevant Buzz zone. (Stay zones will be shown by flashing

indicators. See Section 12. A Stay zone cannot be selected as a Buzz zone; the Stay status must

be cleared first).

Repeat steps 2 until all the required Buzz zones are programmed.

Press the [#] key to exit the buzz programming mode.