To Stay Arm; Quick Stay Arming; Stay Arm And Go - Inhep Digital Security IDS404 User Manual

IDS404 USER MANUAL
3. Press [9] then press [1] or [2] for the required profile.
4. Press [! ! ! ! ! ] to enter. A long double beep should be heard.
5. Program STAY and BUZZ zones for the profile or
profile (See sections 12 and 13).

5.3.2 To Stay Arm

1. Select the required STAY PROFILE .
2. Ensure that the READY indicator is illuminated; if not, check
that all protected doors and windows are closed and that motion
has ceased in the areas covered by motion detectors.
3. If necessary, close the front door.
4. Press the [#] key to cancel any unintended entries.
5. Enter a valid [
6. open the front door. If the front door is opened the
DO NOT
system will arm in AWAY mode.
7. The ARMED indicator will illuminate and the keypad buzzer will
sound on and off for the duration of the exit delay.
8. The AWAY indicator will remain extinguished.
9. Any STAY zones (shown by a steadily illuminated indicator) will
be automatically bypassed.
10. Ensure that you enter only those zones that are bypassed.

5.4 Quick Stay Arming

(Hold down the key until the keypad buzzer sounds)
It is possible to STAY arm by holding down the [5] key until the
keypad beeps. There is no exit delay.

5.5 Stay Arm and Go

(Hold down the key until the keypad buzzer sounds)
12 IDS404 USER MANUAL NO. 700-277-01A ISSUED SEPT 2004 VER 1.01
[#] + [USER CODE]
(Do not leave premises)
].
USER CODE
[5]
[6]
the
ARM