Removing The Cavity Lamp Holder, The Stirrer Motor And Cavity Thermostat #2 - KitchenAid KAC-48 Technical Education

REMOVING THE CAVITY LAMP HOLDER,
THE STIRRER MOTOR, AND CAVITY THERMOSTAT #
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug microwave oven or disconnect
power.
2. Remove the microwave oven from its
mounting location (see page 2-4 for the
procedure and do procedure in reverse).
3. Remove the cabinet from the oven (see
page 4-4 for the procedure).
Stirrer Motor Cavity Therm. #2
4. Remove the hood exhaust fan motor (see
page 4-8 for the procedure).
5. Remove the two top subpanel screws from
the rear panel (see the top-right photo).
Cavity Lamp Holder
4-
Top Subpanel
Rear Screws
6. Lift the right-rear air guide and unhook it
from the right-front air guide.
7. Pull the power supply cord off the right-
front air guide.
8. Remove the five indicated screws from
the top subpanel. Remove the left air grille
and the wire grille from the oven after the
screws are removed.
Top Subpanel
5 Top Subpanel Screws
Wire Grille
Left Air Grille
Continued on the next page.
Right Rear Air Guide
Right Front
Air Guide
Power Supply Cord