Table of Contents
Advertisement
7.
Cut the foam tape at the three indicated
locations on the side of the cooling fan
shroud.
8.
Disconnect the red and white wires from
the high-voltage transformer terminals.
9.
Disconnect the two wires from the power
resistor terminals.
10. Cut the wire tie from around the power
resistor wires.
11. Remove the resistor wires and the red
and white high-voltage transformer wires
from the cooling fan shroud.
Cut Foam Tape
On Shroud
(3 Places)
Power Resistor Wires
Cut Wire Tie
High-Voltage
Transformer Wires
4-
12. Slide the cooling fan motor shroud out of
the oven.
13. To remove the high-voltage capaci-
tor:
a) Discharge the high-voltage capacitor
by touching the leads of a 20,000 Ω re-
sistor from each of the capacitor leads
to chassis ground.
b) Remove the high-voltage diode from
the capacitor (see page 4-20 for the
procedure).
Remove Cooling
Fan Motor Shroud
High-Voltage
Capacitor Leads
Advertisement
Table of Contents
