Table of Contents
Advertisement
d) Open the microwave oven door.
e) Using a putty knife, pry the stirrer mo-
tor cover, and the plastic nails, off the
top of the oven cavity. NOTE: The
cover is sealed to the top by a Silastic
adhesive. Also, the stirrer fan will be
loose when you remove the cover.
Plastic Nails
Stirrer Motor Cover
f) Use the putty knife and scrape the old
Silastic
from around the stirrer fan
™
opening. Use a piece of fine sandpaper
to clean any debris from the surface.
™
Remove Silastic
™
4-
REASSEMBLY NOTES:
•
Be sure to reinstall the stirrer fan blade
on the motor shaft before you reinstall the
cover.
Stirrer
Motor Shaft
Stirrer
Fan Blade
•
Apply a 1/8˝ bead of Silastic
stirrer motor cover opening. Make sure
that the bead goes completely around the
opening with no breaks, so that a complete
seal is made between the cover and the
top of the oven cavity. Install the plastic
nails into the bushings after the cover is in
place.
around the
™
Advertisement
Table of Contents
