Alpine INE-S920E Owner's Manual page 91

01GB00INE-S920E.book Page 91 Tuesday, June 12, 2012 10:56 AM
For INE-S920E
5
Remove the mounting sleeve from the main unit (see
"Removal" on page 91).
Slide the unit into the mounting sleeve and secure it.
Mounting Sleeve
(Included)
Pressure
1
*
Plates
1
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
* The supplied face plate may be mounted.
6
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*1) already
attached to the vehicle's chassis. Connect all the
leads of the INE-S920E according to details
described in the CONNECTION section.
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
• For the screw marked "*2," use an appropriate screw for the chosen
mounting location.
01GB06INE-S920E.fm
Dashboard
This unit
2
Face Plate* (Included)
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
7
Slide the INE-S920E into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Take the face plate off, and secure the ground lead of the unit to
a clean metal spot using a screw (*) already attached to the
car's chassis.
Attach the Original Mounting Bracket to each side of the
INE-S920E/INE-Z928E, using the screws supplied with INE-
S920E/INE-Z928E.
Ground Lead
*
Mounting
Bracket
Chassis
ALPINE INE-S920E/INE-Z928E 68-21057Z31-A (EN)
Bracket keys
(Included)
Screws (M5 × 8) (Included)
Face Plate (Included)
91
-EN