Nimbus Water Systems Five Water Maker WM5-50 Quick Manual page 5

1. Insert polished faucet base and rubber seal onto base of faucet
and insert base assembly down through the sink hole.
2. From underneath the sink, push the 1/4" black drain tubing
attached to the system onto the 1/4" fitting located on the faucet
base.
3. Locate the extra piece of 3/8" white tubing and push one end
onto the larger 3/8" fitting located on the faucet base.
4. Slide white plastic spacer open-end-up onto the threaded fau-
cet stem (2).
5. Loosely thread the 3/8" washer (3) and mounting lock nut (4)
onto the threaded stem.
6. Thread faucet quick-connect adapter (5) on to threads of faucet
stem. NOTE: This connection should be hand-tightened only. Push
one end of 3/8" blue tubing into 3/8" connection.
8. Position the faucet to the desired handle orientation. Slip the
slotted washer (1) between the white plastic spacer and the sink.
Securely hand tighten the mounting nut.
9. Firmly insert spout assembly into the top hole of faucet body
(approximately 1/4"). You may swivel the faucet left or right.
Push Handle Airgap Faucet
41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, email: sales@nimbuswater.com
Airgap to system drain
(1/4" black tubing)
Metal base plate
Rubber seal
1
2
3
4
5
Faucet to drain saddle
(3/8" white tubing)
Product water
(1/4" blue tubing)
5