Chauvet Q-Wash 436Z-LED Quick Reference Manual page 2

Q-Wash™ 436Z-LED QRG
About this
Guide
Disclaimer
Safety Notes
Contact
What Is
Included
AC Power
Power Linking
AC Plug
Replacing the
Fuse
The Q-Wash™ 436Z-LED Quick Reference Guide (QRG) has basic
product information such as connection, mounting, menu options, and
DMX values. Download the User Manual from
more details.
The information and specifications contained in this QRG are subject to
change without notice.
·
DO NOT open this product. It contains no user-serviceable parts.
·
DO NOT look at the light source when the product is on.
·
CAUTION: This product's housing may be hot when lights are
operating.
·
Mount this product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
·
DO NOT leave any flammable material within 50 cm of this product
while operating or connected to power.
·
USE a safety cable when mounting this product overhead.
·
DO NOT operate this product outdoors or in any location where dust,
excessive heat, water, or humidity may affect it.
·
DO NOT operate this product if the housing, lenses, or cables appear
damaged.
·
DO NOT connect this product to a dimmer or rheostat.
·
ONLY connect this product to a grounded and protected circuit.
·
ONLY use the hanging/mounting bracket or the handles to carry this
product. Do not carry by the moving head.
·
In the event of a serious operating problem, stop using immediately.
·
The maximum ambient temperature is 104° F (40° C). Do not operate
this product at higher temperatures.
Outside the U.S., United Kingdom, or Ireland, contact your distributor to
request support or return a product. Visit
information.
·
Q-Wash™ 436Z-LED
·
Power Input Cord
·
2 Omega Brackets
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 2 Q-Wash™ 436Z-LED products at 120 VAC or 6 at
230 VAC. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and
rating.
4. Screw the fuse holder cap back in place and reconnect power.
·
·
·
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
2
www.chauvetpro.com
www.chauvetpro.com
Safety Cable
Warranty Card
Quick Reference Guide
Screw Color
Brown Yellow/Brass
Blue
EN
for
for contact
Silver
Green