Hameg HM 8131-2 Manual page 56

How to input numbers?
"Now move the cursor one position to the right. Use button
to select the 5. Move the cursor again one position to the right and
use button b to select 6. This will yield the desired display."
FR: 102.5600000 kHz
-val+ <cur>
a b c
Holding + resp. – depressed will automatically
increase resp. decrease the value. It is hence
unnecessary to repeat pushing these buttons in order to
increase or decrease. This allows a fast change of values. Of
course, the amount of increment resp. decrement is
determined by the position of the cursor.
STOP
STOP
"You can enter 150 kHz just by remaining e.g. in the 1/
th
100 position, but it will cost your time. Moving the
cursor by 3 positions to the left in order to enter the 5 will
TiPP speed matters up."
”
Input via the knob
"Select the basic menu using the button group
following display:"
Fr. 1.0000000 kHz
Sin Tri Sqr -->
1
2 3 4
e
"Push button [FREQ] in order to call up the frequency function,
the display will show:"
Fr: 1.0000000 kHz
-val+ <cur>
Below the display there is the button group
c and d ,associated with the display function < cur >, the cursor
can be moved. As an example the value 102.56 kHz shall be
entered:
FR: _1.0000000 kHz
-val+ <cur>
a b c
"Push button c of group
cursor 2 positions to the right. Now turn the knob
clockwise until you get this display:"
56
d

so you get the
g
h
e f
5 6

. With the buttons
d

below the symbol < and move the
STOP

Should you have gone too far turning the knob
counterclockwise will get you there.
TiPP
"Now push button
2 positions to the right. Turn the knob softly clockwise until you
get this display:"
FR: 102.0000000 kHz
-val+
a
"Now move the cursor one position to the right and use the knob
”
to enter 5. Then move the cursor again one position to the right
and enter 6. This will yield the desired display:"
FR: 102.5600000 kHz
-val+
a
STOP
If the cursor as in this example is positioned below the
th
1/100
decrement the value in 1/100
TiPP
This allows to change values quite fast. The value is always
influenced in the digit above the cursor. So if the cursor should be
positioned below the 3
would be incremented resp. decremented in 100 kHz steps. The
”
knob is hence well suited to enter or change values quickly,
any entry will be effective immediately.
”
softly
d below the symbol > and move the cursor
<cur>
b c d
<cur>
b c d
digit turning the knob will increment resp.
th
steps.
rd
digit left of the decimal point the value
Subject to change without notice