THIS OR ANY OTHER APPLIANCE. 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER Electric Fireplace Models: TBREF36, Homeowner's Installation & Operating Manual 4758 BREF cover CFM Specialty Home Products www.majesticproducts.com •...
Please read the Installation & Operating Instructions before using this appliance. Thank you, and Congratulations on your purchase of a CFM Specialty Home Products Electric Fireplace. : Read all instructions and warnings carefully before starting installation. Failure to follow these MPORTANT instructions may result in possible electric shock, fire hazard, and/or injury, and will void the warranty.
General Information 1. Read all instructions before using this appliance. 2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this appliance. Keep combus- tible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (1 m) from the front of this appliance.
Mantels The height that a combustible mantel is fitted above the fireplace is dependent on the depth of the mantel. This also applies to the distance between the mantel leg (if fitted) and the fireplace. For correct mounting height and width, refer to Figure 2a and 2b.
Fig. 3 Adjustable drywall strip (nailing flange). FP549 9/29/97 Finishing BR/BC CAUTION: All joints between the finished wall and the appliance surround (top and sides) may be sealed only with noncom- bustible material. Only noncombustible material can be applied as facing to the appliance surround (the black painted face).
8. Connect the ground wire from the wall switch to the wire grouping from the power supply and the ground stud in the junction box. 9. Make sure the red wire (L2) in the junction box has a closed end splice or a wire nut properly applied. 10.Ensure all connections are tight.
120 Volt Unit Installation 1. Locate the switch under the logset on the left front corner of the unit. 2. Check the voltage selection switch position to ensure it is in the 120 Volt position. 3. Loosen the screws securing the junction box cover and remove the cover.
Screen Kit Installation 1. Remove the plastic bag from each screen. 2. Remove the four (4) metal clips, two (2) for each side of the fireplace opening. 3. Slide screen panels against sides of the fireplace opening. 4. Align each metal clip with the hole it was removed from, while at the same time, hooking the clip through the last wire of the screen.
Electrical Wiring Diagram with Heater and Integral Remote Control 4 BLACK 14 BROWN 25 RED 23 WHITE 1. Heater Element 2. Limit Control, 175/20 DIF 3. Relay Switching, 120V, 50/60Hz 4. Fan/Heater Motor 5. Thermostat 6. Switch, Rocker 7. Switch 8.
Electrical Wiring Diagram without Heater and Integral Remote Control 7 WHITE 8 WHITE 1 BLACK Fig. 7 Wiring diagram for models without heat. 10007572 4 BLACK 3 BLACK BLACK 6 WHITE WHITE BLACK 2 BLACK 5 WHITE CFM Component Identification 1.
The control compartment is located inside the fireplace behind the steel curtain near the left front corner. To ac- cess the controls, simply slide the steel curtain open. 1. ON/OFF Switch The ON/OFF switch is for supplying power to light ef- fects of the fireplace.
TBREF36, TBREF36NH CFM Specialty Home Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. TBREF36, TBREF36NH Electric Fireplace 10007572 4758 BREF parts 1/05 ��...
For TEMCO FIREPLACE PRODUCTS Electric Fireplaces BASIC WARRANTY: CFM Specialty Home Products (hereinafter referred to col- lectively as the "Company") warrants that your new Majestic Fireplaces fireplace is free from manufacturing and material ® defects for a period of one year from date of installation, sub- ject to the following conditions and limitations.