Table of Contents
Advertisement
Installation & Operating Instructions
A manufactured (mobile) home OEM installation must
conform with the Manufactured Home Construction and
Safety Standard, Title 24CFR, Part 3280, or, when such
a standard is not applicable, the Standard for Manufac-
tured HOme Installations, ANSI/NCSBCS A225.1, or
Standard for Gas Equipped Recreational Vehicles and
Mobile Housing, CSA Z240.4.
This gas appliance must be installed by a qualified
installer in accordance with local building codes or, in
the absence of local codes, with the current CSA B149.1
Installation Code (in Canada) or the current National Fuel
Gas Code Z223.1/NFPA 54 when installed in the United
States.
This appliance, when installed, must be elecrically con-
nected and grounded in accordance with local codes
or, in the absence of local codes, with the current CSA
C22.1 Canadian Electrical Code: ANSI NFPA 70-1987
when installed in the United States.
FOR SAFE INSTALLATION AND OPERATION PLEASE
NOTE THE FOLLOWING:
1 . This appliance gives off high temperatures and should be
located out of high traffic areas and away from furniture and
draperies.
2. Children and adults should be alerted to the hazards of the
high surface temperatures of this appliance and should stay
away to avoid burns or ignition of clothing.
3. CAUTION: Due to high glass surface temperature, chil-
dren should be carefully supervised when in the same
room as your appliance.
�������
�
4. Under no circumstances should this appliance be modified.
Parts removed for servicing should be replaced prior to
operating this appliance again.
5. Installation and any repairs to this appliance must be
performed by a qualified installer, service agency or gas
supplier. A professional service person should be contacted
to inspect this appliance annually.
6. Control compartments, burners and air passages in this ap-
pliance should be kept clean and free of dust and lint. Make
sure the gas valve and pilot light are turned off before you
attempt to clean this appliance.
7. The venting system (chimney) of this appliance should be
checked at least once a year and if needed your venting
system should be cleaned.
8. Keep the area around your appliance clear of combustible
materials, gasoline and other flammable vapor and liquids.
This appliance should not be used as a drying rack for cloth-
ing, nor should Christmas stocking or decorations be hung
in the area of it.
9. Under no circumstances should any solid fuels (wood, coal,
paper or cardboard etc.) be used in this appliance.
78674
��� ����� ����
����� ������
�� ��� ����� �����
����� �������
����� ����� ��������
�� ����� ������
10. For safe operation, the glass door must be closed.
11. Do not use this heater if any part has been under water.
Immediately call a qualified service technician to inspect the
heater and to replace any part of the control system and any
gas control which has been under water.
12. Do not operate appliance unless completely installed as per
installation instructions.
13. This appliance may be used in a bedroom installation. Install
in accordance with local building codes and regulations.
14. Never use your appliance as a cooking device.
WARNING: Check with your electronics manufac-
turer before installing a television or other electronic
device above this fireplace.
DV5200
Certified To
ANSI Z21.88-2005 / CSA 2.33-2005 / UL 307B
Vented Gas Fireplace Heater
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the
fireplace ON.
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found
with your furnace heat exchanger or car engine. It
is not unusual for your gas fireplace to give off some
odor the first time it is burned. This is due to the
manufacturing process.
Please ensure that your room is well ventilated
-open all windows.
It is recommended that you burn your fireplace for at
least four (4) hours the first time you use it. If the op-
tional fan kit has been installed, place the fan switch
in the "OFF" position during this time.
This appliance may be installed as an OEM instal-
lation in a manufactured (mobile) home and must
be installed in accordance with the manufacturer's
instructions and the Manufactured Home Con-
struction And Safety Standard, Title 24 CFR, Part
3280 or Standard for Installation in Mobile Homes,
CAN/CSA Z240MH.
This appliance is only for use with the type of gas
indicated on the rating plate. A conversion kit is
supplied with the appliance.
Proposition 65 Warning: Fuels used in gas, wood-
burning or oil fired appliances, and the products of
combustion of such fuels, contain chemicals known to
the State of California to cause cancer, birth defects
and other reproductive harm.
California Health & Safety Code Sec. 25249.6
Temco DV5200 Series
3
Hide quick links:
Advertisement
Table of Contents
