Post Flight Checklist - BNF UMX Radian Instruction Manual

Flying Tips continued
Low Voltage Cutoff (LVC)
Low Voltage Cutoff (LVC) pulses the power to the
motor when the voltage gets low. When the motor
power pulses, land the aircraft immediately and
recharge the fl ight battery.
Disconnect and remove the Li-Po battery from the
aircraft after use to prevent trickle discharge. Fully
charge your Li-Po battery before storing it. During
storage, make sure the battery charge does not
fall below 3V per cell.
LVC does not prevent the battery from over-
discharge during storage.
NOTICE: Repeated fl ying to LVC will damage the
battery.
NOTICE: When fi nished fl ying, never keep the
aircraft in the sun. Do not store the aircraft in a
hot, enclosed area such as a car. Doing so can
damage the foam.

Post Flight Checklist


1. Disconnect the fl ight battery from the
ESC (required for safety and battery life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the
aircraft.
Repairs
Repair the aircraft using foam-compatible CA
glue (Cyanoacrylate adhesive) or clear tape. Only
use foam-compatible CA glue, as other types of
glue can damage the foam. When parts are not
repairable, or for a list of all replacement and
optional parts, refer to the list at the back of this
manual.
NOTICE: Use of foam-compatible CA accelerant
on your aircraft can damage paint. DO NOT handle
the aircraft until accelerant fully dries.

4. Recharge the fl ight battery.
5. Store the fl ight battery apart from the
aircraft and monitor the battery charge.
6. Make note of the fl ight conditions and
fl ight plan results, planning for future
fl ights.
EN
9