NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury.
Box Contents Dual Rates Installed Included High 100 % 8.5mm Brushed Motor Timer Settings First Flight 10 Min. 8 Min. DSM2®/DSMX® AS3X Receiver/ESC USB Li-Po Charger To register your product online, go to www.e-fl iterc.com 2 x (SPMSA2030L) on the board Required to Complete: DSM2/DSMX 4-Channel Transmitter...
Charging Warnings The Battery Charger (EFLC1008) included with your • Always inspect the battery before charging. aircraft has been designed to safely charge the • Always disconnect the battery after charging, Li-Po battery. and let the charger cool between charges. •...
Wing Installation 1. Slide the wing into the wing slot on the fuselage until the holes line up with the screw holes on the bottom. 2. Secure the wing using 2 screws. 3. Cut the loop tape (A) into 3 pieces and apply them around the screws in the battery holder, as shown.
Installing the Flight Battery and Arming the ESC Arming the ESC also occurs after binding as previously described, but subsequent connection Lower throttle and of a fl ight battery requires the following steps. throttle trim to lowest settings. AS3X Power ON the transmitter, then The AS3X®...
Control Direction Test Move the controls on the transmitter to make sure the aircraft control surfaces move correctly. Always keep throttle at the low position during testing. Down Elevator Elevator Left Rudder Right Rudder Control Centering Before fi rst fl ights, or in the event of a crash, make sure the control surfaces are centered when the transmitter controls and trims are neutral.
Flying Tips Consult local laws and ordinances before choosing drift downwind. It is best that you search for a location to fl y your aircraft. thermals upwind, so that you can follow a thermal downwind if it is pushed downwind. We recommend fl...
Flying Tips continued Low Voltage Cutoff (LVC) Repairs Repair the aircraft using foam-compatible CA Low Voltage Cutoff (LVC) pulses the power to the glue (Cyanoacrylate adhesive) or clear tape. Only motor when the voltage gets low. When the motor use foam-compatible CA glue, as other types of power pulses, land the aircraft immediately and glue can damage the foam.
Motor Service CAUTION: DO NOT handle propeller parts while the fl ight battery is connected. Personal injury could result. IMPORTANT: Removing tape or decals can remove paint from the fuselage. NOTICE: DO NOT remove the gearbox from the aircraft. Damage to the aircraft will result. •...
Troubleshooting Guide AS3X Possible Cause Solution Problem Control surfaces Control surfaces may not have been Center control surfaces mechanically by not at neutral po- mechanically centered from factory adjusting the U-bends on control link- sition when trans- ages mitter controls are Aircraft was moved after the fl...
Page 12
Troubleshooting Guide (continued) Possible Cause Solution Problem LED on receiver Transmitter is too near aircraft during Power off transmitter, move transmitter a fl ashes rapidly binding process larger distance from aircraft, disconnect and aircraft will and reconnect fl ight battery to aircraft not bind to and follow binding instructions transmitter...
Limited Warranty What this Warranty Covers If you as the purchaser or user are not prepared Horizon Hobby, Inc. (“Horizon”) warrants to the to accept the liability associated with the use original purchaser that the product purchased (the of the Product, purchaser is advised to return “Product”) will be free from defects in materials the Product immediately in new and unused and workmanship at the date of purchase.
the outside of the shipping carton. Service estimates are available upon request. You must include this request with your item NOTICE: Do not ship LiPo batteries to Horizon. submitted for service. Non-warranty service If you have any issue with a LiPo battery, estimates will be billed a minimum of ½...
Compliance Information for the European Union Declaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2014010402 Product(s): EFL UMX Radian BNF Item Number(s): EFLU2980 Equipment class: The object of declaration described above is in conformity with the requirements of the specifi cations listed below, following the provisions of the European R&TTE directive 1999/5/EC, EMC Directive...
Page 16
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambio Part # • Nummer Description Beschreibung Description Descrizione Numéro • Codice Ultra Micro Radian: Spinner Set (3): Jeu de cônes (3) : Set ogiva (3): Ultra EFLU2903 Ultra Micro Radian Ultra Micro Radian Micro Radian Spinner Set...
Page 17
Optional Parts and Accessories • Optionale Bauteile und Zubehör • Pièces et accessoires optionnels • Componenti e accessori opzionali Part # | Nummer Description Beschreibung Description Descrizione Numéro | Codice AC/DC 3.7V Li-Po AC/DC-3,7V-Li-Po- Chargeur Li-Po Caricabatterie Li-Po EFLC1000 Charger Ladegerät CA/DC 3,7V CA/CC da 3,7V...
Need help?
Do you have a question about the UMX Radian and is the answer not in the manual?
Questions and answers