Advertisement
EVO Loudspeakers hooked up to
outputs can be instructed to automatically set their correct
delay and level to perform optimally with EVO Loudspeak-
ers hooked up to
delay will also be added to the
make sure the
Loudspeakers are the acoustic
focus. Before starting, check that the
off. If it is on, then use the rear panel switch (Feature 14,
page 6) to enable the
1. Position the Measurement Microphone in the optimum
position. This is located equidistant from each
(delay) EVO Loudspeaker (in most cases on the central
axis of the listening area), approximately 10 feet away.
10'
2. Press the round delay
is released the
indicator flashes and the EVO
Loudspeakers hooked up to the
emit a test signal. Then the EVO Loudspeakers hooked
up to the
outputs emit a test signal.
3. When the correct delay and level for the
Loudspeaker/s have been set the
indicator illuminates.
AUTO EQ SETTING
EQ SET
EQ SET
MAIN OUT
AUX OUT
SETUP 1&2
SETUP 3&4
AEQ ON
HOLD TO CLEAR MAIN
HOLD TO CLEAR MAIN
Pressing any button during the Delay Setting routine will
abort the process and settings will return to previous
values.
If an error is detected during the Delay Setting routine, this
outputs. A Haas
will be shown on the
Loudspeakers to
an attempt will be made to restore any Delay settings to
their previous values.
indicator is
button.
Press the round
Setting routine will run again. Previous Delay Settings do
not have to be cleared first.
Press-and-hold this button and all previous Delay settings
will clear and the
After each
flash once to remind you that this setting can be locked.
Once the desired
formed and all are satisfactory, they can be "locked in" as
the default or
1. On the rear panel, use a pin or matchstick to engage the
button. When the button
2. Once engaged, the
outputs
3. All
DELAY SETTING
POWER
DELAY SET
SETUP
HOLD TO CLEAR DELAY
RS-232
button again and the Delay
indicator will go out.
routine, the
routines have been per-
system settings.
(Feature 14, page 6).
indicator will illuminate
continuously.
buttons will now be disabled until the
Lockout Switch is disengaged.
INTERFACE
LINK OUT
LINK IN
4 B
indicators, and
indicator will
FLOATING BALAN
MONO
SUM
3 A
Advertisement
