AT&T SynJ SB67158 User Manual page 31

Getting started
Telephone base setup
Record music or a message using the corded handset:
When the telephone is idle, press MENU
1.
2. Press or
3. Press or
ENTER.
MENU/
4. Press or
ENTER.
Press
MENU/
When the screen shows M.O.H. record ENTER=Start, pick up the handset.
5.
6. When your audio device is ready to play, press
telephone. You hear the voice prompt "Record after the tone. Press stop
when you are done." Start playing your audio device or speak after the
beep. The audio plays through the speakerphone and a counter on the
screen shows the elapsed time. The maximum record time is three
minutes, at which time the telephone automatically stops recording and
the recording is saved.
ENTER to stop recording and return to the previous menu. To
7. Press
MENU/
exit without making changes, press EXIT.
NOTES:
• If you want to record a piece of new music or a message while the
music on hold is in use, M.O.H. currently in use. Please try again
later. displays on the screen.
• If you start to record a piece of new music from an audio device but there is no audio
device connected, No Device is connected to the headset jack at base. displays on the
screen. Please check the connection on the telephone base and the audio device.
• If there is silence detected for six seconds while recording or your audio device volume
is too low, the recording stops and the display automatically returns to the previous
menu. This means the recording was unsuccessful. The M.O.H. default music plays when
calls are on hold until you successfully record new music or a message.
• If you fail to record a message, try speaking louder into the corded handset or playing
the volume louder on your audio device. If you are using the audio cable, ensure that it
is fully plugged into the HEADSET/AUX IN jack.
to scroll to Base setup. Press
to scroll to Music on hold. Press
to scroll to Record new M.O.H.
.
/ENTER
ENTER.
MENU/
MENU/
25
M.O.H. record
ENTER=Start
M.O.H. record
00:06
ENTER=Stop
ENTER on the
M.O.H. currently
in use. Please
try again later.