Telephone Base Installation; To Connect The Corded Handset And Power Adapter To The Telephone Base - AT&T SynJ SB67158 User Manual

Getting started

Telephone base installation

To connect the corded handset and power adapter to the telephone base

Plug the large end of the
power adapter into a power
outlet not controlled by a
wall switch.
Plug the small end of the power adapter
into the power jack at the bottom of the
telephone base. Route the power adapter
cord through the slot on the bottom of
the telephone.
NOTE: For complete instructions on installing the cordless handset, see Add and register
handsets on page 10 of this user's manual, or refer to the SynJ SB67108 user's manual. For
complete instructions on installing the expansion deskset, see Add and register desksets on
page 11 of this user's manual, or refer to the SynJ SB67148 user's manual. You can visit
www.telephones.att.com/smb
IMPORTANT INFORMATION
• Use only the power adapter supplied with this product. To order a replacement power adapter,
visit our website at
1 (888) 915-2007
• The power adapter is intended to be correctly oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
www.telephones.att.com
.
In Canada, dial
Raise the two antennas for
optimum wireless range and
performance. For greater
range, add optional repeaters
(AT&T model SynJ SB67128).
Plug the end of the coiled
handset cord into the
HANDSET jack on the left side
of the telephone.
to download the user's manuals.
,
or call
1 (866) 288-4268
6
.