Keithley 706 Instruction Manual page 53

Table 3-8. Hierarchy of Command Execution
3-12
Command
D
P"
T"
G"
U"
J"
K"
M*
0*
Definition
Display Mode
Program
Trigger Modes
Prefix Modes
Alternate Output
ROM and LED Test
EOI
SRQ
I/O Port
Notes
DO = Channel
Dl = Interval Time
D2 = Time
D3 = Date
D4 = Display Message
PO = Step
Pl = Single
P2 = Continuous
P3 = Inspect Mode
P4=Disable Inspect Mode, return to previous
P mode.
TO = Start on Talk
Tl = Stop on Talk
T2= Start on GET
T3 = Stop on GET
T4 = Start on "X'
T5 = Stop on "X"
T6 = Start on External
17 = Stop on External
GO = Channel Data sent with prefix.
Gl = Channel Date sent without prefix.
G2= Buffer State sent with prefix.
G3 = Buffer State sent without prefix.
G4= I/O Port sent with prefix.
G5= I/O Port sent without prefix.
G6 = Time/Date sent with prefix.
G7 = Time/ Date sent without prefix.
G8 = Status Word sent with prefix.
G9 = Status Word sent without prefix.
GlO=Settle Time sent with prefix.
Gil = Settle Time sent without prefix.
G12=Alarm Time sent with prefix.
G13=Alarm Time sent without prefix.
G14= Interval Time sent with prefix.
G15= Interval Time sent without prefix.
G16i First/Last sent with prefix.
G17 = First/Last sent without prefix.
G18= Previous relay set up buffer location sent with
prefix.
G19= Previous relay set up buffer location sent
without prefix.
UO = Channel
Ul = All Channels
U2=I/O
U3 = Date and Time
u4 = status
U5 = Settling
U6 = Alarm
U7 = interval
U8 = First/ Last
U9 = Previously recalled buffer location.
JO= Run Debug Test
KO = EOI sent on last byte out.
Kl =Send no EOI
See Table 3-9
Onnn, where O=command n =0 to 377 octal
- I --=---