Table of Contents
Advertisement
Table 3-7. Model 706 Device-Dependent
Commands
Command
Definition
Notes
A
Set Number of Poles
A0 = Matrix Mode
Al = 1 -pole
A2 = 2-pole
A3 or A4 = 4pole
:
Display Channel
Bnnnn
Close Channel
Cnnnn
D
Display Mode
DO = Channel
Dl = Interval Time
D2 = Time
03 = Date
D4 = Display Message
E
Date Format
EO = American Date Format
El = International Date Format
L
Set First Channel
Fnnnn
Prefix
GO=Channel Data sent with prefix.
Gl = Channel Data sent without prefix.
G2= Buffer State sent with prefix.
G3= Buffer State sent without prefix.
G4= l/O Port sent with prefix.
G5= I/O Port sent without prefix.
G6 = Time/Date sent with prefix.
G7 = Time/Date sent without prefix.
G8 = Status Word sent with prefix.
G9 = Status Word sent without prefix.
GlO = Settle Time sent with prefix.
Gil = Settle Time sent without prefix.
G12=Alarm
Time sent with prefix.
G13 = Alarm Time sent without prefix.
G14= Interval Time sent with prefix.
G15 = Interval Time sent without prefix.
G16= First/Last sent with prefix.
G17 = First/Last sent without prefix.
G18 = Previous relay set up buffer location sent
with prefix.
G19 = Previous relay set up buffer location sent
without prefix.
H
Settle Time
Hnnn.nnn
I
Save
II, 12, 13, 14, 15...175, IO clears all buffers.
ii
Debug Test
JO = Run Debug Test
EOI
KO= EOI transmitted on last byte out
Kl = Send no EOI
ii
Set Last Channel
Lnnnn
SRQ
Mnnnn
N
Open Channel
Nnnnn
0
I/O Port
Onnnn
P
Program
PO = Step
Pl = Single
P2 = Continuous
P3 = Inspect Mode
P4= Disable Inspect Mode, return to previous
P mode.
Q
Set Alarm Time
Qhh:mm:ss
.
3-10
Advertisement
Table of Contents
