Operation; Operation Modes; Manual Mode; Single Mode - ELGO Electronic P40-SN002 Series Operation Manual

7. Operation

7.1 Operation Modes

7.1.1 Manual mode

With the keys F1 & F3 the axis shown in the display can be driven manually or with the inching function.
In register "delay hand" a time (in sec) can be set. If the hand mode is selected and the entered time value is
worked off the manual mode will automatically switch from creep speed to fast speed.

7.1.2 Single mode

Using the single mode (single set mode) a single set can be processed. The arrow keys can be used for
navigation. The inputs of the values in the target window are done manually. Every input has to be select by
pressing the Enter button. To load deposited values of the material table, you have to select the respective
material number in menu "Mat:" at the lower boarder of the display. After dialing you can select the material
number by pressing the Enter button and the values will be loaded according to the actual action of
positioning.

7.1.3 Program mode

Using the program mode up to 1000 individual programs can be programmed and individually driven. All
positions are successively driven. This process must be started once using the start command.

7.1.3.1 Input of a program

Starting the program mode will open an input window in which the desired program number can be entered.
After this operation the "Enter key" has to be pressed to open the program window.
At first start the user has to enter a memory block number.
Entering the memory block number is only necessary if the user is in the first data set of the program is. To
ensure faster entry in all other data sets only the following elements have to be changed:
Target value Backgauge
Position mode
Set Number
Quantity
Cutting length
If you are in input mode then the cursor is blinking. To end the entry you have to press the enter key to
confirm. The last entered value will be immediately saved. The buttons F1 and F3 are used to navigate
through the individual program sets. Also it is possible to select the set number with the cursor and adjust the
corresponding set number. Also it is possible to load material values out of the material table for Angle and
Gap with select the kind of material. More detailed information about material table you can see in the
corresponding chapter. If all elements edited you have to select the menu element "Set number" by using the
cursor and then press the button F2. This will end the program in the last row and the last set will be marked
with the letter 'E'.
- 36 -
Operation