Machine Setting; Gap Setup (Cut Gap); Angle Setup (Cut Angle) - ELGO Electronic P40-SN002 Series Operation Manual

6.3. Machine setting

6.3.1. Gap Setup (Cut gap)

Minimum gap:
Enter the small cut gap of the shear (e.g. 0.5 mm) and after that drive manually to the smallest position by
using F1-key or F3-key. When reached this position press the F2-key (teach). The incremental measurement
value is assigned to the gap and entered in the field "min." is saved.
Maximum gap:
Enter the large cut gap of the shear (e.g. 10.0 mm) and after that drive manually to the largest position by
using F1-key or F3-key. When reached this position press the F2-key (teach). The incremental measurement
value is assigned to the gap and entered in the field „max." is saved.

6.3.2. Angle Setup (cut angle)

Minimum angle:
Enter the small possible cut angle of the knife bar (e.g. 0.0°) and than drive manually to the smallest position
by using F1-key or F3-key. When reached this position press the F2-key (teach). The incremental
measurement value is assigned to the angle and entered in the field "min. "is saved.
Maximum angle:
Enter the large possible cut angle oft he knife bar (e.g. 10.0°) and then drive manually to the largest position
by using F1-key or F3-key. When reached this position press the F2-key (teach). The incremental
measurement value is assigned tot he angle and entered in the field „max value"is saved.
6.3.3. Cutting length Setup
If the same analog measuring system which is used for the angle also used for the angle Cutting length, then
it is necessary, set the values for the cutting length calculation.
Setting values with minimum angle:
Place the cursor in the first row and first column of the table (line: min; column: S. Beg).
Now, enter the smallest possible cut angle. Let down the cutting blade to beginning of the cut (till the point,
where the upper beam and lower beam of the scissors just touch) and press the F2 key.
Now place the cursor on the field in the first row and second column (row: Min; column: S. End)
and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the
minimum angle are set up.
Setting values with maximum angle:
Place the cursor in the second row and second column of the table (line: max; column: S. Beg).
Now, enter the biggest possible cut angle. Let down the cutting blade to beginning of the cut (till the point,
where the upper beam and lower beam of the scissors just touch) and press the F2 key.
Now place the cursor on the field in the first row and second column (row: Max; column: S. End)
and let down the cutting blade to the end of the cut. Now press the F2 key again. Thus the values for the
maximum angle are set up.
ATTANTION!
First check end-switch function!
- 34 -
Configuration and Functions